Essential Pre-Startup Guidelines for Silicone Extruders
Time：
2017-10-25
Startup procedure: 1. Inspect the machine to ensure it is in good condition and check that all wiring connections are secure, with no loose wire ends. 2. Turn on the main power supply and allow the machine to heat up. Once the set temperature is reached and maintained for five minutes, increase the speed to 5 Hz, then feed the film into the system and run it slowly. After silicone emerges from the die outlet, gradually accelerate the speed. Once the silicone has softened, connect the die head, adjust the die gap, and begin normal production. 3. When shutting down, completely extrude all silicone remaining in the barrel (avoid prolonged idling). Open the die head and thoroughly clean out any residual material to prevent contamination in the next batch. Finally, turn off the power supply.
Power-on requires reading.
1. Check that the host is in good condition and inspect the wiring for any loose or detached wire ends.
2. Turn on the main power supply and heat the machine. After heating to the set temperature for five minutes, increase the speed to 5 Hz, load the film, and run it slowly. Once material begins to extrude from the die outlet, gradually accelerate the speed. Once the silicone has softened, connect the die head, adjust the die gap, and proceed with normal production.
3. When shutting down, thoroughly extrude all silicone rubber from the barrel (do not allow the machine to idle for extended periods). Open the die head and clean out any residual material to prevent interference with the next production run, then turn off the power.
Related news
Shuangda
Hebei Shuangda Rubber Machinery Co., Ltd.
Tel：400-0319-386
Landline：+86-319-6017632
Email：shuangdaxiangsu@126.com
Official website：www.shuangdajx.com
Addr：Liyuantun Industrial Zone, Weixian County, Xingtai City, Hebei Province
Copyright © 2022 Hebei Shuangda Rubber Machinery Co., Ltd.