Silicone hose extruder simple troubleshooting
Time：
2018-01-16
|
Problem Description |
Cause Analysis |
Solution |
|
|
Stomata |
Temperature is too high |
Reduce the temperature of the oven,discharge the porosity of the compound |
|
|
There is moisture in the compound |
Change the glue test machine |
||
|
Excessive vulcanizing agent |
Adjust the proportion of curing agent |
||
|
Pimple |
There are dead glue in the plastic vulcanization |
Feel the barrel and the nose by hand to observe whether the temperature rise of the temperature of the rubber material is vulcanized,clean up the head,the row of plastic if no,if the cleaning screw |
|
|
Deviation from the core |
The inner mold is too large |
Replace the internal mold |
|
|
Inside and outside the mold is not correct |
Adjust the inner mold hole to the middle of the outer die hole |
||
|
Bad outside diameter exterior |
Scratched |
Scratch of outer mold |
Replace the outer mold |
|
The appearance of no light |
Outside the model is too large |
Replace the outer mold |
|
|
The appearance of ripples |
The outer mold is too small |
Replace the outer mold |
|
|
Other electrical appliances are not normal boot |
The emergency stop button is not open |
Open the button |
|
Related news
Shuangda
Hebei Shuangda Rubber Machinery Co., Ltd.
Tel：400-0319-386
Landline：+86-319-6017632
Email：shuangdaxiangsu@126.com
Official website：www.shuangdajx.com
Addr：Liyuantun Industrial Zone, Weixian County, Xingtai City, Hebei Province
Copyright © 2022 Hebei Shuangda Rubber Machinery Co., Ltd.